Wen 4016 16 Electric Chainsaw Manuale Utente Scaricare il pdf (Pagina 8)

ASSEMBLY

INSTALLING THE GUIDE BAR AND SAW CHAIN

1. Loosen the locking knob counter clockwise and remove the

sprocket cover

2. The adjust block should already be attached to the guide bar. Make sure

the adjust block is turned all the way counter-clockwise and then put the

saw chain on the guide bar.

3. Place the guide bar onto the bar studs and the chain around the sprocket.

Make sure the chain cutters on top of the guide bar face in the direction

that the chain runs. See below picture.

4. Install the sprocket cover by turning the locking knob clockwise. Don’t tighten it before adjusting

chain tension.

5. Adjust the chain tension by turning the tension wheel clockwise. The chain is

correctly tensioned when it is still possible to raise it by 2-3 mm in the middle of

the guide bar.

6. Tighten the sprocket cover by turning the locking knob clockwise.

Caution: Proper saw chain tension is extremely important. If saw chain is too tight, the guide

bar and saw chain will be quickly damaged. If the saw chain is too loose, it may get out of

the guide bar groove and cause an injury.

Note: A new chain will stretch so adjust the tension after a few cuts. Watch saw chain tension

carefully for the rst half hour of cutting.

WARNING - Check the chain tension before each use.

Always use protective gloves.

WARNING - Never try to run the chainsaw without sprocket

cover securely tightened.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Nessun commento

Wen 4016 16 Electric Chainsaw Manuale Utente Pagina 8